f
OC L
l "
OC
"
ill b di
l
d
If output current is higher than
OCP Level, "
OCP TRIPPED
" message will be displayed.
It disables output voltage & current from sources.
If you wish to output voltage & current, please remove the load and used the method below
the causes of trip occuring Trip are :
First, The different OCP Level can cause trip. Therefore raise level value to get resolution.
Second, when you used load that causes counter-electromotive force from coil & motor.
Can be protected as below diagram
p
g
Third, When sources used by load also can cause tripping. This happens when
source one is used from load
▌
When
OCP Trip occurs, "
OCP TRIPPED
" will be displayed on VFD.
▌To clear OCP Trip, raise OCP Level in the first step.
To set up Level, press OCP Key.
OCP TRIPPED
VFD Display Description
▌
Press OCP button once more while
"
OCP ON
" is displayed.
VFD Display Description
▌Use cursor key to change value.
▌U
d
it h t
i
l
l
OCP ON
OCP-LEVEL 10.0A
▌Use encorder switch to raise level.
▌When the setting is done, press OCP Key.
VFD Display Description
Message above will be displayed, and return to condition before trip.
▌Second step to clear OCP Trip.
To disable OCP press OCP Key
CHANGED
To disable OCP, press OCP Key.
VFD Display Description
▌
Press left or right cursor while
"
OCP ON
" is displayed.
VFD Display Description
▌
To save changes, press OCP key while
"
OCP OFF
" is displayed.
VFD Display Description
CHANGED
OCP OFF
OCP ON
VFD Display Description
Message above will be displayed, return to condition before trip.
≫ Related Remote Interface Command
[SOURce:]CURRent:PROTection{<current>}
[SOURce:]CURRent:PROTection:STATe {0|1|OFF|ON}
[SOURce:]CURRent:PROTection:TRIPped?
[SOURce:]CURRent:PROTection:CLEar
CHANGED
[SOURce:]CURRent:PROTection:CLEar
Refer: Method to raise level value when there is a trip
CURR:PROT:TRIP? Return value "1"
Check whether it is OCP Trip condition
CURR:PROT 10
OCP Level Setting
CURR:PROT:CLE
OCP Trip Clear
Method to disable OCP when there is a Trip
CURR:PROT:TRIP? Return value "1"
Check whether it is OCP Trip condition
CURR:PROT:STAT OFF
Disable OCP
CURR:PROT:STAT OFF
Disable OCP
CURR:PROT:CLE
OCP Trip Clear
- 30 -