5. Cut the supply cable, remove
the already existing tube to
replace it with the one provided
in the box of the installation
without visible wire. Make sure
you keep enough wire to go
through the tube and to plug
into the junction box.
6. Pass the supply cable through
the tube provided for this
purpose and pass the wire
through the plate.
7. Remove the tube already
present on the towel warmer
and replace it with the tube
available in the box provided
for hard-wired installation. Rivet
the base onto the nut with the
fixing screw.
8. The supply cable should exit
from the rear of the product.
11. Press the button to turn it on
or off, select on the timer
2 or 4 hours.
10 Install the base
with the screws.
9. Connect the supply cable to the
junction box and aim the plate in
the junction box.
