27
ODB COMPANY
800-446-9823
SKB700
Operating Section
3.1 Starting Engine
Always make sure the PTO is disengaged before
starting unit. (See figure 3b)
Thoroughly read and understand the safety and
pre-operating sections of this manual before star-
ing the engine.
DO NOT start the engine in an enclosed building.
Proper ventilation is required before starting the
engine.
Throttle Control
The Module Uses J1939 throttle aka Torque Speed Control (TSC1)
PRIOR TO STARTING ENGINE
, select the proper throttle control mode and parameters required for
application
Throttle is set through the Throttle Configuration Menu in the Control module
*Under CAN Configuration, you will find Throttle Type Selection / TSC Min Speed / TSC Max Speed /
TSC Ramp Rate / Throttle Curve Selection*
Manual Throttle Options
1) Vernier Throttle
Standard Up and Down Throttle between the set Minimum and Maximum selections.
The Ramp rate is the rate of acceleration in RPMs per second.
2)Multistate Throttle
Provides for one, two, three, or four specific operating speeds. Pressing the Up and
Down Buttons adjusts engine speed between the selected multistate speed selections.
3) High/Low
Engine Accelerates to the Max Speed Setting with the Up button pressed. When the Up
button is released, the engine goes back to idle speed.
Summary of Contents for SKB700
Page 35: ...35 ODB COMPANY 800 446 9823 SKB700 Operating Section...
Page 36: ...36 ODB COMPANY 800 446 9823 SKB700 Operating Section...
Page 37: ...37 ODB COMPANY 800 446 9823 SKB700 Operating Section...
Page 138: ...138 ODB COMPANY 800 446 9823 SKB700 INDEX Volt Meter 76 W Water Temperature Sender 82...
