40
ODB COMPANY
800-446-9823
SKB700
Operating Section
3.7 Engaging the PTO
PTO shown disengaged
Thoroughly read and understand the safety and
pre-operating sections of this manual before star-
ing the engine.
figure 3b
Make sure the intake hose is properly attached
and make sure the front of the hose is clear of
any objects which could be inadvertently vacu-
umed during the PTO engagement process.
figure 3d
figure 3c
safety assist cylinder
PTO shown fully engaged
Review the Engine Operating Manual supplied with your leaf
vacuum for specific start-up, maintenance and operating in-
structions. It is especially important to review break-in service
procedures for brand new units.
Engaging the PTO (refer to figures 3b, 3c and 3d):
1. Perform all the pre-starting, pre-operating checks outlined
in the EOM and in this manual.
2. Start the engine as previously discussed in this manual and
in the EOM.
3. Once the engine has been allowed to thoroughly warm up
(engine temperature gauge should read at least 180 de-
grees) pull the throttle control until the engine reaches 1000
rpm.
4. Grasp the PTO handle (fig. 3b) and slowly raise the han-
dle.
NOTE:
Some units have a PTO assist cylinder which
engages the PTO at a specific speed in order to properly
engage the PTO. Because of this the PTO handle only
needs to be raised slightly, then the assist cylinder will take
over and engage the PTO automatically. (fig. 3c)
PTO handle
Summary of Contents for SKB700
Page 35: ...35 ODB COMPANY 800 446 9823 SKB700 Operating Section...
Page 36: ...36 ODB COMPANY 800 446 9823 SKB700 Operating Section...
Page 37: ...37 ODB COMPANY 800 446 9823 SKB700 Operating Section...
Page 138: ...138 ODB COMPANY 800 446 9823 SKB700 INDEX Volt Meter 76 W Water Temperature Sender 82...
