47
ODB COMPANY
800-446-9823
SKB700
Maintenance Section
4.3 Lubrication:
Remove the negative battery terminal before at-
tempting any lubrication procedures.
Thoroughly read and understand the safety and
pre-operating sections of this manual before per-
forming any lubrication procedures.
Figure 4.3A
The following are general lubrication procedures for our
standard units. Any special or custom built units may
have other lubrication procedures not directly mentioned
in this manual. Please consult the factory or your dealer
before any lubricating procedures not specifically men-
tioned in this manual.
Proper lubrication of your unit correlates directly to how
long your unit will last. A properly maintained unit will last
much longer than a unit that is not maintained properly.
NOTE:
Always lubricate bearings at the end of each work
day. This will displace any moisture in the bearings. Also
lubricate thorougly before extended shutdown or storage.
Lubrication Points:
1. Drive Bearings (figure 4.3a):
These bearings are
critical components of the belt-driven units. These
bearings should be greased every 10 hours with ap-
proximately two strokes from the average hand pump
grease gun. The type of grease used in these bear-
ings are also critical to the performance of the bear-
ings. A multi-purpose, heavy-load, high-temperature,
moisture resistant #2 grease is required for the drive
bearings. We recommend L Mantek Elite Supreme
#1 WG Extreme Duty multi-purpose grease. Other
premium quality grease that matches the above re-
quirements may be used but after years of testing we
recommends the Mantek grease.
Summary of Contents for SKB700
Page 35: ...35 ODB COMPANY 800 446 9823 SKB700 Operating Section...
Page 36: ...36 ODB COMPANY 800 446 9823 SKB700 Operating Section...
Page 37: ...37 ODB COMPANY 800 446 9823 SKB700 Operating Section...
Page 138: ...138 ODB COMPANY 800 446 9823 SKB700 INDEX Volt Meter 76 W Water Temperature Sender 82...
