www.odencontrol.se 14
−
Error signal = 40
Actuator type not selected.
−
Error signal = 50
No calibration performed
−
Error signal = 60
Motor overheated
−
Error signal = 70
Motor overheated 10 times. Break power to continue.
7.5.
Status menu (only in version 4.1)
The Status menu shows the actual voltage used and the temperature of the controller and motor. If the temperature
exceeds a pre-set value, the actuator will be turned off. When the temperature falls the actuator will try again to
reach the position. This process will be repeated ten times. After failing to reach the position ten times, the actuator
will be turned off and return a permanent error signal.
7.6.
Parameters in OVP
Parameter Description
Default
value
P30 Turning
Default value
P30 Linear
Closing direction
Sets closing direction. Viewed from the
actuator towards the valve
Clockwise In
Valve pitch
Sets the valve pitch in mm/turn.
-
10 mm/turn
Speed Sets
operating
speed.
50
°
/s
100 mm/min
Acceleration
Sets acceleration in a relative value.
20
20
Torque/Force
Sets maximum torque/force delivered
during regulation.
10 Nm
5000 N
Working range
Sets the actuator working range.
85
°
20 mm
Shut-off
Area near the close position where no
regulation will occur. The actuator will
continue to the closed position to avoid
cavitation problems.
5 % of the
working range
5 % of the
working range
Signal level at open
position
Sets the mA-signal for open position.
20 mA
20 mA
Signal level at
closed position
Sets the mA-signal for closed position.
4 mA
4 mA
Valve reaction at
control signal loss
Decides what happens when control signal
is lost.
Unaffected Unaffected
Power Calibration
after 8h power loss
Automatic calibration after more than 8
hours of power loss. (Includes Time
calibration in OVP version 3.8).
Disabled Disabled
Time calibration
A repeatable power calibration in closed
position. To avoid jamming.
Disabled Disabled
Summary of Contents for P220L
