3
Ordercode: D3915
ODIN CL-4 Connect
IMPORTANT!
The manufacturer will not accept liability for any resulting damages caused by the non-observance of
this manual or any unauthorized modification to the system.
•
Always disconnect power from the mains, when system is not used. Only handle the power cord by
the plug. Never pull out the plug by tugging the power cord.
•
Always operate the unit with the AC ground wire connected to the electrical system ground.
•
Avoid flames and do not put close to flammable liquids or gases.
•
Avoid ground loops! Always be sure to connect the power amps and the mixing console to the
same electrical circuit to ensure the same phase!
•
Avoid installing your equipment very near radio or TV sets, mobile phones, etc., as these can cause
RF (radio frequency) interference.
•
Before changing your grounds around, always turn your amplifiers down.
•
Before switching on or off, make sure that the sound system’s amplifiers are off or turned down: this
will avoid signal peaks, which are annoying and sometimes dangerous (particularly for speaker
enclosures).
•
Do not connect this device to a dimmer pack.
•
Do not open this device.
•
Do not switch the system on and off in short intervals, as this would reduce the system’s life.
•
If device is dropped or struck, disconnect mains power supply immediately. Have a qualified
engineer inspect for safety before operating.
•
If the system has been exposed to drastic temperature fluctuation (e.g. after transportation), do not
switch it on immediately. The arising condensation water might damage your system. Leave the
system switched off until it has reached room temperature.
•
Make sure that the available voltage is not higher than stated on the rear panel.
•
Make sure that the power cord is never crimped or damaged. Check the device and the power
cord from time to time.
•
Make sure that there is sufficient room on all sides of the system for air circulation.
•
Make sure you do not use the wrong kind of cables or defective cables.
•
Never let the power cord come into contact with other cables! Handle the power cord and all
connections with the mains with particular caution!
•
Never remove warning or informative labels from the unit.
•
Never use anything to cover the ground contact.
•
Only use device indoors, avoid contact with water or other liquids.
•
Please turn off the power, when changing the power cord or signal cable, or select the input mode
switch.
•
Prevent distortion! Make sure that all components connected to the ODIN have sufficient power
ratings. Otherwise distortion will be generated because the components are operated at their limits.
•
Repairs, servicing and electric connection must be carried out by a qualified technician.
•
Sometimes, when you want to send one signal to more than one amplifier, you should use a signal
distributor.
•
When connecting the other parts of your sound system, watch out for the so-called “ground loops”.
•
WARRANTY: Till one year after date of purchase.
Summary of Contents for CL-4 Connect
Page 14: ...13 Ordercode D3915 ODIN CL 4 Connect Notes...
Page 15: ...14 Ordercode D3915 ODIN CL 4 Connect...
Page 16: ...2016 ODIN...
