1. Before flying, insert each protecting
guard on the bottom of a rotor housing
as shown and push the guard up
until the clips at its top secure the guard.
2. If you wish to remove the guards for storage,
gently pull apart the clips at the top of each
guard and pull down the base until the guard
is removed.
Connect the battery wire plug with the power
supply wire plug and insert the battery into
the battery compartment.
How to Charge the Drone Battery
Reinstall the Drone Battery
Installing and Removing the Protective Guards
Pic.1
Pic. 2
Pic.3
Disconnect the battery wire plug from
the power supply wire plug . Pull on the
silver foil to remove the battery from the
Drone. Then connect the battery wire
plug with the USB charging cable plug,
and insert the USB interface to any USB
charging outlet to charge the battery.
The USB indicator light illuminates while
charging is proceeding and turns off
once the battery is fully charged. Full
charging time is around 70 minutes.
6