5
Operating Instructions and Parts Manual
24370
MULTI-USE PORTABLE POWER
SOURCE WITH JUMPER CABLES
03/16
2016 ©OEMTOOLS
Press the switch to
check the charge level
of the OEMTOOLS
Portable Power
Source
The indicator lights
will flash one by one
during charging.
Different number of
solid indicators show charge level of the OEMTOOLS
Portable Power Source. All indicators light up when
the charging is paused or completed.
OPERATING INSTRUCTIONS
The OEMTOOLS Portable Power Source Charging
Instructions:
1. Plug the home adaptor into the universal socket.
2. Connect 12V 1A input port of the OEMTOOLS
Portable Power Source to the other end of home
adapter
OR
3. Plug the car adaptor into the socket of cigarette
lighter.
4. Connect 12V 1A input port of the OEMTOOLS
Portable Power Source to the other end of car
adaptor.
JUMP START 12V GASOLINE VEHICLE
INSTRUCTIONS:
1. Make sure that the number of indicators is not less
than 3 bars
2. Connect POSITIVE (RED) clip from Portable Power
Source to POSITIVE (POS, P, +) ungrounded post
of battery. Connect NEGATIVE (BLACK) clip to
vehicle chassis or engine block away from battery.
Connect to a heavy gauge unpainted metal part of
the frame or engine block.
3. WARNING: Do not connect clip to carburetor,
fuel lines, or sheet metal body parts.
4. Attach clips to battery post and twist or rock
back and forth several times to make a good
connection. This helps to keep clips from slipping
off terminals and helps to reduce risk of sparking.
5. Plug the cord of jumper cable into the jump start
socket.
6. Start the vehicle.
7. When the vehicle is started, remove jumper
cable from the OEM Portable Power Source and
disconnect red and black clamps to the vehicle
battery terminals.
8. Leave the vehicle’s engine running.
CHARGING CELL PHONE OR TABLET
INSTRUCTION:
1. Plug the pigtail cable B into the USB 5V 2A output
port.
2. Select appropriate connector and connect it to
your mobile phones or tablet.
3. Press the switch button to charge.
FOR POWER SUPPLY TO 12V VEHICLE
ACCESSORIES OR 12V ELECTRONICS
1. Plug the optional pigtail cable to 12V 10A output
port.
2. Connect the optional pigtail cable and 12V vehicle
accessories or 12V electronics.
3. Press the switch button to power supply.
LED FLASH LIGHT
1. Press the switch 3 seconds to start the LED flash
light
Indicator
Storage Level
Unlit
0%
5 Flashing
10%
1 Solid
20%
2 Solid
40%
3 Solid
60%
4 Slolid
80%
5 Solid
100%
INDICATOR
