WARNING
The following safety information is provided as guidelines to help you operate your Crossbeam under the safest possible conditions. Any tool or
piece of equipment can be potentially dangerous to use when safety or safe handling instructions are not known or not followed. The following
safety instructions are to provide the user with the information necessary for safe use and operation. Please read and retain these instructions
for the continued safe use of your Crossbeam. Failure to follow instructions listed below may result in serious injury. In addition, make certain
that anyone that uses the equipment understands and follows these safety instructions as well.
Explanation of Safety Signal Words
WARNING
:
Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION
:
Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.
CAUTION
:
Used without the safety alert symbol indicates a potentially hazardous situation which, if not avoided, may
result in property damage.
NOTES
:
Provide clarity and helpful information.
Thank you very much for choosing an OEMTOOLS
®
Product!
For future reference, please register your new tool at www.oem-tools.com and complete the owner’s record below:
Model
: _______________
Purchase Date
: ___________
Save the receipt, warranty and these instructions. It is important that you read the entire manual to become familiar with this product before you begin
using it. This product is designed for certain applications only. OEMTOOLS
®
cannot be responsible for issues arising from modification. We strongly
recommend that this product is not modified and/or used for any application other than that for which it was designed. If you have any questions relative
to a particular application, DO NOT use the product until you have first contacted customer service to determine if it can or should be performed on the
product.
WARNING
:
Pursuant to California Proposition 65, this product contains chemicals known to the state of California to cause cancer and birth
defects or other reproductive harm. Wash hands after handling.
Operating Instructions and Parts Manual
24794
Please read and save these instructions. Read through this owner’s manual carefully before using product. Protect yourself and others by observing
all safety information, warnings, and cautions. Failure to comply with instructions could result in personal injury and/or damage to product or property.
Please retain instructions for future reference.
1
7/20
2020 OEMTOOLS
®
2 TON FLOOR JACK CROSSBEAM
FOR CUSTOMER SERVICE
Technical Question?
CALL 1-866-458-2472
customerservice@oem-tools.com
UNPACKING
After unpacking unit, inspect carefully for any damage that may have
occurred during transit. Check for loose, missing, or damaged parts. If
any damage is observed, a shipping damage claim must be filed with
carrier. DO NOT use the OEMTOOLS
®
2 Ton Floor Jack Crossbeam
if broken, bent, cracked or damaged parts (including labels) are
noted. Any Crossbeam that appears damaged in any way, operates
abnormally or is missing parts should be removed from service
immediately. If you suspect that the Crossbeam was subjected to a
shock load (a load that was dropped suddenly, unexpectedly, etc.)
immediately discontinue use until it has been checked by a factory
authorized service center.
