4
Operating Instructions and Parts Manual
25811
1" SQUARE DRIVE
IMPACT WRENCH WITH 6" ANVIL
12/20
2020 OEMTOOLS
®
WARNING
: Disconnect the plug from the power
source before making any adjustments, changing ac
cessories or storing the tool.
To avoid electrical hazards, fire hazards or damage to the
Impact Wrench, use proper circuit protection.
WARNING
: Before use, read and understand all
warnings, safety precautions, and instructions as outlined
in the manual.
Important Safety Instructions
The warnings, precautions, and instructions discussed
in this manual cannot cover all possible conditions and
situations that may occur. The operator must understand
that common sense and caution are factors which cannot
be built into this product, but must be supplied by the
operator.
DISPOSAL
At the end of the useful life of the OEMTOOLS
®
Impact
Wrench, dispose of the components according to all
state, federal, and local regulations.
PURPOSE
The OEMTOOLS
®
1" Square Drive Impact Wrench with
6" Anvil is designed to deliver high torque to tighten or
loosen threaded fasteners. No other use is permitted.
PRODUCT SPECIFICATIONS
Free Speed
3,700 RPM
Average Air
Consumption( 25% )
16 SCFM
Max. Torque
2,168 N-m /1,600 Ft/Lb.
Clutch Type
Rocking Clutch
Exhaust
Side
Length
500 mm/19.7"
Weight
13.5 kg/29.8 Lb.
Air Pressure
90 psi
Air Inlet(Npt)
1/2"
Sound Pressure
112.2 dB
Sound Power
123.2 dB
WARNING
: Double insulated tools are equipped
with a polarized plug (one blade is wider than the other).
This plug will fit in a polarized plug only one way. If the
plug does not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician to install
a polarized outlet. DO NOT change the plug in any way.
Double insulation eliminates the need for the three wire
grounded power cord and grounded power supply
system.
WARNING
: If any part is missing or damaged, DO NOT
plug the Impact Wrench into the power source until the
missing or damaged part is replaced.
WARNING
: To avoid fire or toxic reaction, never use
gasoline, naphtha, acetone, lacquer thinner or similar
highly volatile solvents to clean the tool.
NOISE HAZARDS
1. Unprotected exposure to high noise levels can cause
permanent, disabling hearing loss and other problems
such as tinnitus (ringing, buzzing, whistling or humming
in the ears).
2. Risk assessment of these hazards and implementation
of appropriate controls of is essential.
3. Appropriate controls to reduce the risk may include
actions such as damping materials to prevent work
pieces from ‘ringing’.
4. Use hearing protection as instructed.
5. Operate and maintain the power tool as recommended
in these instructions, to prevent an unnecessary
increase in noise levels.
VIBRATION HAZARDS
1. Exposure to vibration can cause disabling damage to
the nerves and blood supply of the hands and arms.
2. If you experience numbness, tingling, pain or whitening
of the skin in your fingers or hands, stop using the
power tools. You should also seek medical advice from
a qualified occupational health professional.
3. Operate and maintain the power tool as recommended
in these instructions to prevent an unnecessary
increase in vibration.
4. Support the weight of the tool in a stand, tensioner or
balancer, because the operator can then use a lighter
grip to support the tool.
5. Hold the tool with a light but safe grip, taking account
of the required hand reaction forces, because the risk
from vibration is generally greater when the grip force is
higher.
LUBRICATION
To ensure long life of the air tool, be sure to oil the tool
daily before use. Simply pour 4 drops of air tool oil into
air inlet and run tool for a moment to clean.
