Image Functions
3-6
Ex. Width (main scanning direction) = 8.5
″
= 3,400 (@1/400 inch) = X’D48’
Length (Sub-scanning direction) = 11
″
= 4400 (@1/400 inch) = X’1130’
Output resolution = 600 dpi
The specification of Width must be;
A#6 = X’0D’
A#7 = X’48’
The specification of Length must be;
A#8 = X’11’
A#9 = X’30’
As a result the output Main Window width and length may be rounded up as follows.
Width =
[
3400
----------
×
600
÷
8
400
]
= 637 bytes
Length =
[
3400
----------
×
600
400
]
= 6600 raster
* the value in [ ] are rounded up to integer
(4)
Specification by the offset (X1, Y1), width (X2) and length (Y2)
This method is called “clipping”. Main Window can be set by specifying offset (X1,Y1) , width
(X2) and length (Y2). Each dimension are defined as shown in Figure 3. and Figure 3. The unit
of each dimension is 1/400 inch. These dimensions are defined for front side and back side
independently.
NOTICE: When the Jam detection is set OFF, the scanner ignores the length and continues reading.
Table 3.5 Specification by clipping
Register setting
Parameter
Control register No.
value
Default
X direction offset
A#10,A#11
Width
A#12,A#13
Y direction offset
A#14,A#15
Length
A#16,A#17
See example below
Summary of Contents for M3097DE
