DCC-SC01HD32
Rev.900-717-30-00
-
9
8.
Camera Operating Instructions
There are 3 different operating methods, operating with OSD menu, operating without OSD menu, and
operating via PC with dedicated remote control cable connected to the remote control terminals.
Depending on its operating methods, selectable camera settings are different. Please refer to the
selectable settings by each operational method as below.
8.1.
Switch Operation without OSD Menu
Operational Functions
EZOOM, PAN, TILT, and Video Format Selection
EZOOM Operation
EZOOM can be operated with [UP] KEY and [DOWN] KEY.
With [DOWN] KEY, it goes to TELE side, and with [UP] KEY, it goes to WIDE side.
Except when EZOOM is x1.00, it goes to EZOOM
→
PAN
→
TILT
→
EZOOM everytime when
[BACK] KEY is pushed. PAN and TILT values can be set as well.
* When EZOOM is x1.00, PAN and TILT will automatically go back to the center of the image.
Display Format Selection
Video format can be changed as follows, pushing [ENTER] KEY while pushing [BACK] KEY.
720p/60 Y/PbPr
→
720p/59.94 Y/PbPr
→
720p/50 Y/Pb/Pr
→
720p/60 RGB
→
720p/59.94 RGB
→
720p/50 RGB
→
720p/60 Y/Pb/Pr
* The selected settings with operations explained the above can not be saved as they are.
To save those settings, EXIT
→
SAVE shall be done by OSD displayed operation.
* Initial setting is 720p/59.94 Y/Pb/Pr.
8.2.
PC Operation via RS232C
Camera can be controlled via a PC using camera control software, with dedicated remote control cable
(RE-300A) connected to the remote control terminal.
8.3.
Switch Operation with OSD Menu
[ENTER] KEY: To enter into the menu with pushing this button for long.
In the menu, this button works to go to the next menu, and works as [
→
] KEY.
[BACK] KEY: In the menu, this button works to go back to the prior menu, and works as [
←
] KEY.
[UP] KEY: To select items in the menu.
When operating volume type menu, this button makes the value to
＋
direction.
[DOWN] KEY: To select items in the menu.
When operating volume type menu, this button makes the value to
－
direction.
