24
Planetary Final Drive Service Manual
Output Carrier Subassembly
CAUTION:
Safety glasses must be worn during these next steps
.
1.
Place Planet Gear (4B) onto press table. Install Internal Retaining Ring (4E) into the groove
of Planet Gear (4B).
NOTE:
In step below insure to install the Spacer (4F) into the deepest bore side from the
retaining groove of the Planet Gear (4B).
2.
Install Spacer (4F) into bore of the Planet Gear (4B) onto Retaining Ring (4E).
3.
Use tool T-159309 and install both Bearing Cups (4C) with wide face outside into bore of the
Planet Gear (4B). Insure that the Bearing Cups are seated completely against the retaining
ring and thrust washer in the respective sides.
4.
Install Bearing Cone (4D) into Bearing Cup (4C) on both sides of the Planet Gear (4B).
5.
Apply grease and install Thrust Washer (2F) on planet shaft bore top side in Carrier (4A)
planet gear window.
Continued on Next Page
Summary of Contents for Fairfield Torque-Hub S40B Series
