Clamp pincer CP 10 / CP 20 / CC 20
5
Use of clamp pincer
The “Calibration finished” window now opens.
This displays the calculated correlation factor
(Cal.) (ratio between the thrust force of the
plunger to the closing force of the pincer jaws)
for information purposes.
NOTICE
For safety reasons, there is a minimum and maximum calculated correlation factor (Cal.), and an error
message appears if it is either not met, or surpassed. In such event, the calibration must be repeated.
4. Click on the “OK” button.
The pincer test is completed and the PC software changes to the "Status" tab start screen see chapter 7.2,
p. 7-38.
5.2
Working with clamp pincer CP 10 / CP 20 / CC 20
5.2.1 Battery charge level display
The battery charge level is displayed on the battery charger LED (see also chapter 8.3, p. 8-46).
It can also be read directly off the battery.
Fig. 9:
Checking the battery charge level
Press button(Fig. 9/2).
The number of illuminated LEDs (Fig. 9/1) shows the level of charge. A flashing LED indicates less than 10 %
charge level.
Issue 11.15
08902961
5-23
