Oeuf 5SPCR01, Quick Manual

AUSTRALIAN STANDARDS COMPLIANCE

WARNING: TO PREVENT FALLS THE
MATTRESS BASE OF THIS COT SHOULD
BE ADJUSTED TO THE LOWEST POSITION
BEFORE THE CHILD CAN SIT UP
RECOMMENDED MATTRESS SIZE: 690 MM
WIDE X 1300 MM LONG X NO MORE THAN
120 MM THICK

•FAILURE TO FOLLOW THESE WARNINGS AND THE ASSEMBLY INSTRUCTIONS COULD 
RESULT IN SERIOUS INJURY OR DEATH.
•BEFORE EACH USAGE OR ASSEMBLY, INSPECT COT FOR DAMAGED HARDWARE, 
LOOSE JOINTS, MISSING PARTS OR SHARP EDGES. DO NOT USE COT IF ANY PARTS 
ARE MISSING OR BROKEN. ASK YOUR DEALER OR WRITE TO 3 FEET HIGH FOR 
REPLACEMENT PARTS AND INSTRUCTIONAL LITERATURE IF NEEDED. DO NOT 
SUBSTITUTE PARTS.
•WHEN CHILD IS ABLE TO CLIMB OUT OR REACH THE HEIGHT OF 90 CM , THE COT 
SHALL NO LONGER BE USED.
•DO NOT PLACE COT NEAR WINDOW WHERE CORDS FROM BLINDS OR DRAPES MAY 
STRANGLE THE CHILD.
•IF REFINISHING, USE A NON-TOXIC FINISH SPECIFIED FOR CHILDREN

ʼ

S PRODUCTS.

•DO NOT USE A WATER MATTRESS WITH THIS COT
•UPON COMPLETION OF ASSEMBLY, BE SURE ALL SCREWS AND BOLTS HAVE BEEN 
TIGHTENED SECURELY.
•A PERIODIC CHECK SHOULD BE MADE OF ALL SCREWS AND BOLTS AND RETIGHTENED 
IF NECESSARY.
•NEVER USE PLASTIC SHIPPING BAGS OR OTHER PLASTIC FILM AS MATTRESS COVERS 
BECAUSE THEY CAN CAUSE SUFFOCATION.
•DO NOT DRAG COT.
•AFTER COT HAS BEEN COMPLETELY ASSEMBLED, STORE INSTRUCTION SHEET IN 
THIS POUCH.
•UNDER NO CIRCUMSTANCES SHOULD THIS WARNING BE REMOVED FROM MATTRESS 
SUPPORT!

WARNING: TO PREVENT FALLS, THE 
MAXIMUM MATTRESS THICKNESS SHOULD 
NOT EXCEED 120 MM.

4