Offgridtec PSI-PRO Inverter
Important safety instructions
Konto Sparkasse Rottal-Inn
Konto: 10188985
BLZ: 74351430
IBAN: DE69743514300010188985
BIC: BYLADEM1EGF (Eggenfelden)
Sitz und Amtsgericht
HRB: 9179 Registergericht Landshut
Steuernummer: 141/134/30045
Ust-IdNr: DE287111500
Gerichtsstand: Mühldorf am Inn
6.
S
afety instructions for electrical connection
•
Verify that all wiring connections are fixed to avoid the risk of heat accumulation by loose
connections.
•
The protective earthing must be connected to the ground. The cross-section of the wire
should not be less than 4mm2.
•
The DC input voltage must exactly match the parameter table. Too high or too low a DC
input voltage affects the normal operation of the inverter and can even damage it.
•
It is recommended that the length of the connection between the battery and the inverter is
less than 3 meters. If the length is more than 3 meters, the current density of the
interconnector should be reduced.
•
A fuse or a fuse switch should be used between the battery and the inverter; The rated
current of the fuse or crusher should be twice as high as the inverter input current.
•
DO NOT install the inverter near the flooded lead-acid battery, as the spark flight of the
terminals can ignite the hydrogen released by the battery.
•
The AC output terminal is only intended to connect the load. DO NOT connect it to other
power sources or the power supply network, otherwise the inverter will be damaged. Turn off
the inverter before connecting loads.
•
o not connect battery chargers or other similar products to the inverter input terminal;
otherwise, the inverter will be damaged.
General information
Offgridtec GmbH
Im Gewerbepark 11
84307 Eggenfelden
WEEE-Reg.-Nr. DE37551136
Contact
Tel: +49 8721 91994-00
Email: info@offgridtec.com
Web: www.offgridtec.com
GFR: Christian & Martin Krannich
7. Safety instructions for the operation of the inverter
•
When the inverter is in operation, it generates waste heat and can heat the surface. The
temperature can be very high; do not touch the enclosure.
•
When the inverter is in operation, please do not open the housing.
•
The AC output of the inverter is under high voltage, do not touch the cable connection to
avoid electric shock.
