Officine Gullo
10
Picture 2E
There are several screws around the
perimeter of the back panel, to remove the
panel you need to remove all the screws
around the perimeter and them pull away
the panel to access the terminal block.
IMPORTANT ! MAKE SURE TO ALWAYS
DISCONNECT THE APPLIANCE FROM
THE ELECTRICITY BEFORE WORKING
ON IT.
Picture 1E
Electrical Supply.
This appliance requires electrical supply – ensure an appropriately qualified person completes the electrical
connection.
The appliance must be connected to an equipotential system. The connection screw is positioned at the back of the
appliance and is identified by the symbol
Attention!
the manufacturer cannot be held responsible for, and does not cover in the guarantee any damage
resulting from bad or faulty connections.
The appliance may be supplied without the connection cable. In this case, the connection cable must have the
following characteristics: it must be type H05RNF and must have an adequate section for the power of the appliance
(see technical data table).
To install, proceed in the following way:
-Remove the back panel bye removing the screws that are around its perimeter as shown in picture 1E;
-Fit the connection cable through the cable channel, connect the conductor wires to the corresponding terminals in
the junction box as shown in picture 2E below and fix them into place.
-Block the cable with the cable blocker, and reassemble the panel. The ground wire must be longer than the others
so that if the cable blocker should break for any reason, it will disconnect after the hot wires.
The installation of this appliance must conform with all applicable local codes. In the absence of local codes, the
installation must conform to the latest level of the National Electric Code, ANSI/NFPA 70.
11
Officine Gullo
USER MANUAL
INSTRUCTIONS FOR USE
Attention!
Use the appliance only under surveillance.
Fry tops are appliances for cooking meat, fish, eggs, vegetables, cheese, etc.
LOADING
Before using the appliance for the first frying, it is necessary to clean it carefully (see paragraph “cleaning and care”).
Check the connection of the appliance and start it up following the instructions.
When using the hotplate for the first time, it is advisable to let all the hotplates work for a few minutes at maximum
power, in order to remove any humidity from the insulating mass of the elements.
Warning! Never put hands when working.
Check that the griddle is inserted.
Switch on the switch situated above the appliance.
Turn the knob from ”O” into the desired position between 120°F and 560°F; the white and green lights come on.
The green light indicates the presence of electrical tension.
The white light shows that the heating element is working; when the temperature is reached it goes out.
To turn off the appliance turn the knob into position “O”.
SPECIAL INDICATIONS
During use of the fry-top, it is advisable to clean the hotplate and remove all the residue which is deposited, using the
proper brush or a damp cloth.
Attention: The cutting and sharping utensils damage the chromed plate.
Summary of Contents for FLS6EMU
Page 2: ...Officine Gullo 2...
