Officine Gullo GGS8P, Instructions Manual

19

Officine Gullo

CHECKING FOR ADEQUATE VENTILATION

Make sure that the air intake into the room where the appliance is installed is sufficient for an adequate change of air, as 

specified by regulations in effect.

The appliances installed in buildings open to the public must satisfy the following requirements.

Installation rules

The installation and maintenance of the appliance must be done according to the correct procedures and regulation

texts in use, particularly:

• safety standards for the prevention of fire and panic.

Connection and installation of appliance, ventilation and exhaust removal systems, shall be done according to the 

Manufacturer’s instructions and by qualified technicians and according to the regulations in effect. The electric wiring shall 

conform to the regulations in effect. 

All fire prevention codes shall be observed.

a) General indications 

(Rules valid for GB only)

- For all appliances:

Gas safety Regulations, 1984; Health and safety at Work Act, 1974 Codes of Practice, BS 8173, 1982, The Building

Regulations 1985; The Building Standards Regulations, 1981, the IEE Regulations and the by-laws of the local Water 

Undertaking.

The local gas Region or LPG supplier and the local authority and the relevant recommendation of the British Standards 

(latest editions) concerned.

The installation, transformation and repair of appliances for professional kitchens as well as removal due to malfunction, 

and the supply of gas, may be made only by means of a maintenance contract stipulated with an authorized sales office 

and in observance of technical regulations.

The appliance can be installed by itself or in a series side by side with appliances produced by us. 

There must be a minimum distance of at least 10 cm between the appliance and the sides of the nearby cabinets made 

of inflammable material. 

Take suitable measures to guarantee thermal insulation of the inflammable sides, such as, for example, the installation of 

protection against radiation. 

The appliances must be installed in a suitable manner, observing the safety standards. 

The small feet are adjustable to level the appliance.

PIPE FOR GAS CONNECTION

The gas connection must be done with steel or copper pipes, or otherwise with flexible steel pipes in compliance 

with the national norms, if any exist. Each appliance must be provided with a cut-off cock for rapid interruption of the 

gas supply. Once the appliance has been installed, it is necessary to check for gas leaks for the pipe fittings; do not 

use a flame for this purpose but a non-corrosive substance such as soapy water or foamy substances as contained 

in leakfinder sprays. All our appliances undergo careful testing: the type of gas, the operating pressure and the 

category are indicated on the data plate.

NB:

 The year of the appliance manufacture is shown in item “N” on the data plate. The first two numbers (e.g. 08..) 

represent the year of manufacture.