EN
38
27 - Setting the Self-Clean Mode
To Set the Self-Clean Mode
1. Turn the cooking knob into the CLEAN position.
2. CLEAN & TIME appear.
3. The clean time is displayed automatically, its standard value
is 3 hours.
4. At the end of the programmed cleaning time, the oven will
automatically turn off.
5. To stop the cleaning mode at any moment, move the two
knobs from the cleaning position.
Do not attempt to open the door while the door is locked. The
“AUTO LOCK” text will flash until the motor stops. When the
text is displayed, the door cannot be opened. Check that the
door has been locked and will not open before starting the
Self-Clean mode.
If door does not lock, rotate the cooking mode knob into the
OFF position and do not start self-clean; contact service.
If the door is in the open position when this mode is selected,
the “AUTO LOCK” text will flash until the door is closed. The
latch will not move until the door is closed. Do not attempt
to reopen the door while the latch is in motion as you could
damage the mechanism.
To Change the Cleaning Time
1. To change the setting from 3 hours, select either 2 hours
for light soil or 4 hours for heavy soil immediately before
starting.
2. To change the hours, touch the
TIME
key.
3. The hours will flash.
4. Use
+
or
-
keys to change the value.
5. To change the minutes, touch the
TIME
key again.
6. The minutes will flash.
7. Use
+
or
-
keys to change the value Hold the key to
change by 10 minute increments.
8. Touch
TIME
or wait a few seconds to confirm the new
value.
To Delay the Start of Cleaning
1. Follow steps 1 through 7 above.
2. Touch the
TIME
key and verify that “STOP TIME” appears
on the display. The hours will begin flashing.
3. Use
+
or
-
keys to change the stop time value.
4. To change the minutes, touch the
TIME
key, the minutes will
flash.
5. Use
+
or
-
keys to change the value. Hold the key to
change by 10 minutes increments.
6. Touch
TIME
or wait a few seconds to confirm the new
value.
7. The latch starts moving to lock the oven door, the display
shows “DELAY”.
8. When the delay time expires, self-cleaning will start.
9. At the end of the programmed cleaning time, the oven will
automatically turn off.
10. “End” will appear on the temperature display, “CLEAN” on
the mode display and “TIME” on the clock display will start
flashing until the
TIME
key is touched or the knob is moved
to the OFF position.
In order to check the cleaning or the stop time during a
delayed clean, simply touch the
TIME
key until “TIME” or
“STOP TIME” writings are displayed.
