TUNING AFTER BREAK-IN
Idle adjuster screw &
Barrel Stop
Lean
Rich
Close master needle by turning clockwise until it stops.
Then open needle by turning counterclockwise 3 turns
(rich setting).
When running car, adjust carb with 1/8 clockwise turns,
slowly leaner, until the top speed good. Check engine
temp, if possible, for no more 250 degrees.
Adjust barrel stop so it will not close, accept for a small gap.
This gap will be the idle setting. You will notice the idle will
increase with a wide gap.
Adjust low end needle for best throttle response. Use only
small turns. From idle, give it full throttle, if throttle is slow
lean out needle until good.
APPENDIX PAGES
Summary of Contents for 1/8 SCALE OFF-ROAD BUGGY
Page 32: ......
Page 35: ...APPENDIX PAGES...
