NOTICE:
SOME VIOLATOR RTR KITS WILL COME WITH “SHAFT START”
(same as Rotor Start). THEREFORE, A PULL START ENGINE IS NOT
USED AND THE SHAFT START BACK PLATE IS ALREADY
INSTALLED.
BEFORE YOU CAN USE THE SHAFT START MOTOR HANDLE, YOU
MUST FIRST GET OR BUY A STANDARD 7.2 BATTERY PACK.
AFTER POWERING UP THE MOTOR HANDLE, INSERT THE SPECIAL
DOG BONE SHAFT AND TURN OVER THE ENGINE.
CHECK BEFORE STARTING:
1) IS THE FUEL LINE PRIMED?
2) IS THE CARBURETOR SET FOR BREAK-IN SETTINGS?
3) IS THE RADIO ON AND THROTTLE AND BRAKE LINKAGE
CHECKED AND OKAY TO START?
4) MAKE SURE RADIO AND CAR RECEIVER BATTERY ARE ON AND
WORKING WITH GOOD POWER.
5) PLACE THE GLOW HEATER ON PLUG.
6) HOLD THE CAR AND STARTUP THE ENGINE, BY PUMPING
THROTTLE SLIGHTLY. DO NOT HIGH REV ENGINE WHEN IT
STARTS, AT THIS TIME!
SHAFT START
Summary of Contents for 1/8 SCALE OFF-ROAD BUGGY
Page 32: ......
Page 35: ...APPENDIX PAGES...
