READ THIS BEFORE RUNNING
Running a nitro kit is fun and easy, but to make this a safe
rusting.
• Clear oil and dirt from chassis with a electronic safe
and good experience you must observe a few rules. This
degreaser.
kit is extremely fast, easily over 40MPH, and can seriously
injure someone if you are not careful.
Precautions
• This kit is not a toy. Always run car with a second
Where to run car?
person as a spotter and pitman.
• Any running area you choose must be dry. Do not run
car near any water or wet dirt.
• Hot Parts - The pipe, manifold, engine and head are very
• Do not run on public streets. It is very easy to have the
hot and will cause burns.
car run over or damaged by hitting the curb.
• Do not operate car in tight confined places. The car is
• Rotating Parts - Keep hands away from the drive train,
very fast and will easily hit something.
wheels, and engine when engine is running.
• Do not run near people or animals.
• Radio - Check batteries life before running the car. If
• Due to noise, you will want to consider the surrounding
radio does not have full control of the car with steering
area when operating the car.
and/ throttle/ or brake do not run until corrected. Failure to
• Do not operate the car at night. You will not be able to
correct this will result in possible injury and damage to the
drive it without hitting something.
car or property.
• Do not operate the car indoors. Engine exhaust is not
healthy.
• Glow fuel - Don’t leave the glow fuel unattended with the
lid off. Fuel contains Methanol and Nitro Methane and is
Glow Fuel
• Glow fuel is poisonous!
flammable and poisonous.
• Glow fuel is flammable!
• Do not leave in fuel bottle with lid off at any time.
Store fuel in cool ventilated location. Refer the glow fuel
• Don't use any fuel other than glow fuel in this engine.
label for additional precautions.
• Don't use Gasoline as fuel in glow engines!
• Car Fuel tank - Never store fuel in car tank, it will ruin the
First Time Starting the Engine
engine if left in tank.
Caution! When starting engine make sure the following is
observed.
• Oil the air filter FOAM Element! OFNA #10015.. $2.95
• Set engine Master needle to 4 turns (rich setting)
• Do not do this alone, get an experienced friend to help at
first.
• Fill fuel tank, try not to spill fuel. Do not spill fuel on
receiver
• Hold car off the ground, so it will not runaway when first
starts
• Turn on Radio and check the linkage before starting
engine.
• Turn on car receiver battery switch.
• Always have an air filter on the carburetor to keep dirt
out.
Engine Break-in
• See Engine Page.
Emergency Stopping Engine When Running
• Remove air filter and cover carb. intake.
• Squeeze fuel line and hold until engine stops.
• With a rag, cover exhaust outlet.
Storing Car After Running
• Remove fuel from tank and fuel lines
• Turn off radio in car
• Put a few drops of after run in engine to keep it from
The car is very fast
and will easily hit someone.
THINGS NEED BESIDES THE KIT
RADIO CONTROL UNIT
12V Battery for Starter Box
(must have)
Glow Plug Heat with Battery & Charger
# 10227....$$19.95
(please note OFNA Glow Heats available)
AA Batteries ( 12 pcs ) for radio
Note: Carefully read the instruction manual of your
2 channel radio controller before using.
Radio must be set at neutral position
before installing in the kit.
SEQUENCE TO SET NEUTRAL
Note: Pro kit does not include engine!
Glow Fuel
20%
Install AA batteries in Radio.
Extend the antenna.(Transmitter)
Install batteries into Car receiver .
After installing the battery, connect the
battery box.
Extend the antenna. (Receiver)
Set the trim-lever at center.
Turn on the switch. (Transmitter)
Turn on the switch. (Receiver)
Make sure the servos are in command.
When the operation stick is in neutral,
servo horns must be in neutral as will.
*Adjustment can be made by re-
installing the servo horn.
Turn off the switch. (Receiver)
Turn off the switch. (Transmitter)
Retract the antenna. (Transmitter)
11
11
12
13
REQUIRED FOR OPERATION
Bottle’s with spout
# 10160 - large 500cc
# 10161 - large 500 ccAuto Stop
# 10162 - small 250cc
# 10164 - CNC spout 500CC
# 10167 - CNC spout 800CC
SUITABLE SERVO SIZE
29mm - 42mm
15mm - 21mm
36mm-41mm
3.5 cc (21 Class) ENGINE
REAR EXHAUST
Off-Road Starter Box, 12V motor
# 10250 - 1/8 scale Starter Box
# 10253 - 1/8 scale Starter Box w/ Panel
# 92571 - Power Panel Glow Heater
# 92572 - Cable for Glow Plug
Off-Road Starter Box, two 550 motors
# 10248 - 1/8 scale Starter Box
# 10249 - 1/8 scale Starter Box,RTR
Optional Parts
TOOLS NOT INCLUDED IN KIT
Phillips Type Screw Drivers ( L )
Phillips Type Screw Drivers ( S )
Needle Nose Pliers
Cutter
Curved Scissors
Knife
Instant Cement
Cross Wrench
#17109 $3.95
Glow Plug & 17MM Cross Wrench
#10801 $6.95
Masking Tape
Paints
Grease
Brush
More Optional Parts . . .
#10211 NiHm Battery Flat
Pack .. $29.95
# 10214 NiHm Battery Pack
Charger.. $7.95
# 51007 OFNA/Picoo Glow
Plug .. $4.95
INCLUDED WITH KIT
Shock Oil
1.5mm
Hex Wrench
Grease Box
2.5mm
Hex Wrench
3mm
Hex Wrench
5mm
Hex Wrench
7mm and 5.5mm
Hex Wrench
OFNA/Picco
O-1 bp
#51217
