Soft
Firm
Soft
Firm
SET-UP GUIDE
RIDE HEIGHT ADJUSTMENT
2mm
Hex Screw
Use a 2mm hex screw to adjust the ride height.
Screwing in the 4x10mm set screw....Ride height becomes lower.
Uncsrewing the 4x10mm set screw..Ride height becomes higher.
1 2 3
1 2
3x12mm
Screw
3x12mm
Screw
3x12mm
Screw
3x12mm
Screw
FOR A STICK PACK BATTERY
40048
Stick Pack
Battery Holder
(5 Cell)
10211
Stick Pack
Battery(5 Cell)
( Not Included.)
* Use tape to secure the battery.
* Insert battery wire into
receiver box and connect to
the switch.
Tape
40048
Battery Holder
Mount
*Hole for fuel tank.
*Hole for engine.
Cut out for engine.
*For the exhaust outlet
of the muffler.
*Hole for antenna pipe.
Cut out the body as shown.
CUTTING OUT THE BODY AND PAINTING
*Make a 8mm hole
for body mount.*
Use a neutral detergent to
remove any dirt and oil.
Mask the windows from
the inside with masking tape.
Apply internal color decals
from the inside and paint the body
with polycarbonate spray paints.
Spray Paint
Cutting holes.
*Make a 8mm hole
for body mount.
31149
Body Clips
31149
Body Clips
MOUNTING THE BODY