PAINTING TIPS
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STER 7
STER 10
STEP 8
STEP 9
Wash the inside of the body with detergent to
remove any oil and dirt. Dry with lint free towel
or a hair dryer. (Keep your hand clean.)
Tools required are: Curved scissor, hobby knife
and a quality masking tape. These can be pur-
chase at your local hobby supplier.
Use the curved scissors to trim the body to
the guide lines provided on you body shell.
Use masking tape on the inside of the body to
mask out your design and windows prior to
painting. Press down the edges!
Paint the inside of the body!
Use a spray color suitable for polycarbonate.
(Paint the darkest color first.)
Allow the paint to dry for at least an hour!
Remove the masking tape and protection film
from the outside of the body.
Apply the decals to the outside of the body.
We suggest use a hobby knife to cut them out.
Use a hobby knife to cut holes for
fuel tank ,
engine and antenna tube .
Make two 7mm holes for the body posts; one at
the front and one at the rear.
the
Drill two 7mm holes in nylon wing.
Using the measurements provided in the
instruction. Use the clip provided to secure the
wing to the wing mount posts.
Mounting the body to the buggy using
body clips provided.
the
For BUGGY
