7
8.
Device description
The µdox multi-parameter hand-held meter gives precise, reliable measurement of the water
values pH, redox, total hardness, acid capacity, and dissolved oxygen, even at trace levels. The
µdox unit is characterised by ease of operation combined with high-quality measurement stand-
ards.
Only OFS sensors can be connected to the µdox hand-held meter.
The LAB-Pocket meter case is part of the equipment, as well as the hand-held meter and sen-
sors.
9.
Initial set up / operation
For initial set up, the sensor cables should be inserted into the sensor sockets (2) as per the
diagram in the chapter “Socket panel”, and tightened using the screw connector.
One or two sensors can be connected, whereby the choice of sensors sockets (2) is free.
Switch the hand-held meter on using the key pad [ON/OFF] and check charge status (11) of the
integrated battery in the display (see chapter “Display) top right.
If the charge status of the battery falls below 30%, the USB sensor cable must be connected to
the charging socket (1) in the socket panel. The USB sensor cable must then be connected to a
PC or a USB power supply unit to charge the battery. The remaining battery time is shown
optically in percent (%) via the battery symbol (11).
10.
Operation
10.1
Operating elements and connections
10.1.1.
Key pad
In the operating instructions, keys are indicated using square brackets [ … ], for example
[OK]
.
Socket panel
Display
Key pad
Summary of Contents for udox
Page 1: ...dox Operating instructions Version 1 6 8...
Page 2: ......
