Important Precautions
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
Do not power on the cleaner when it is out of the water.
Strictly prohibit using the cleaner beyond its operating conditions. Please read the manual carefully, and use it according to the manual.
We have no responsibility for any loss or injury caused by improper use.
Use the accessories recommended or sold by the manufacturer only.
This model mainly applies to swimming pools with a flat floor.
The cleaner should not be used by children under the age of 8 or people with mental disorders. Please do so under the supervision of
the guardian if necessary. Please do not allow children to ride on it or play as a toy.
Use the original and authorized power adapter only.
It must be replaced by the after-sale professionals if the power line is damaged.
The power line must be connected to a leakage protected and earthed socket when charging.
Do not operate the cleaner when there are people in the pool.
Always clean and wash the filter tray after use.
Power off the cleaner when maintaining, cleaning or not using it.
The cleaner should be stored in a cool and ventilated place, away from direct sunshine.
Charge the battery under the permitted condition. The cleaner should be stored in a cool place when charging, meanwhile do not
place or be covered with anything to prevent the damage of internal electrical components caused by overheating of the power unit.
Only professionals can disassemble the sealed driving kit of the cleaner.
Close the pool filtration system before use.
The cleaner should be charged every three months if it needs to be stored for a long time. Please use the original and authorized
adapter only to ensure that the battery power is maintained at 40%-60%. The battery voltage will be lower than the over-discharge
protection voltage due to the self-discharge of battery if not charging the battery for a long time, which will lead to fatal damage to the
battery if continuing too long. Please be careful.
Prohibit charging the battery under the condition of fire or extreme heat. Do not use or store the cleaner near the heat source.
Prohibit piercing the cleaner shell with nails or other sharp objects, and prohibit hammering, impacting and throwing the cleaner.
I.
The robotic pool cleaner Cyber is a new type of rechargeable automatic cleaning equipment for pools with the function of automatic
beaching.
The cleaning function is upgraded, and the half-way turn-back function is activated for 5-12 times every 20 times the wall is hit, so that
the center of the swimming pool is no longer a dead corner for cleaning.
Introduction
III. Specifications
IV.
1.
a.
b.
Operation instruction
Precautions
Install the brush before use to avoid possible dirt leaks.
Please ensure that the top cover of the cleaner is tightly assembled to its chassis.
c.
d.
e.
f.
g.
After turning on, the cleaner must be placed in the pool within 20 seconds
Put into or lift out of the pool with the cleaner bottom towards the wall to avoid any possible scratches to the pool.
Power off the cleaner after use.
Do not touch the wall to avoid scratching the wall or damaging the cleaner when putting into or lifting out of the pool.
It is necessary to stay on the water surface for 10-15 seconds until water flows out from the cleaner to the pool before being placed on the ground.
g.
2.
a.
*
*
*
b.
*
Lift the handle or clips of the cleaner out from the pool.
Quick operation
Plug in the cleaner with the supplied adapter and charging line to charge the battery.
Turn the switch knob to OFF before charging.
Clean the charging port before charging.
Keep the machine charging port and the adapter dry when charging.
Turn the switch knob to power on or off the cleaner
Please put into water within 20 seconds after turning on.
c.
d.
e.
3.
There are two nozzles on the cleaner, one of them opens once the other closes. Water flows out through the open nozzle to thrust the
cleaner forward. Adjust the nozzle by turning it to control the cleaner route.
Status
Solid blue
Blue light fast flashing
Blue light slow flashing
Flashing Red
Meaning
Switch on
Cleaner is out of water
Cleaner is working in the pool
low battery
Turn the switch knob to ON, the cleaner is power-on and the indicator light is steady blue, then put it into water. About 15 seconds after
power-on, the cleaner begins to work, and the blue light flashes.
When battery power is low, the cleaner will move close to the pool wall. The red-light fast flashes. The cleaner stops running when it
runs out of battery.
Indicators
Functions and adjustment of nozzles
a.
The nozzles of the cleaner are marked with angles (0°-40°).
The cleaner moves in an approximately straight line when the nozzle angle is 0°.
The cleaner moves in a more curved line at a larger angle from 0°-40°.
Setting 1: default setting: 0°-20°, for most of pools.
Setting 2: 0°-40°, when setting 1 does not manage a full coverage of the pool.
Setting nozzle angle and cleaner route
Setting 3: 20°-20°, for round pools.
Note: These are the recommended settings. Different settings may work better for your pool.
4.
a.
Clean the filter tray
Open the cleaner by the clips
b.
Take out the filter tray
V.Trouble shooting
VI.
VII.
This product has passed all quality control and safety tests, conducted by the technical department of the factory.
Warranty information:
1.
2.
3.
4.
5.
Packing list
Warranty
The warranty period is 12 months of use on the motors and electrical parts from the date of purchase and established under the terms
of the Consumer Code and the legal guarantee against hidden defects and vices in any case applies in the conditions of the articles in
the country of purchase.
The warranty is void if the product is handled or repaired by nonqualified person in unauthorized repair services.
Broken parts are not covered by the warranty.
The warranty only covers factory defects, it does not cover damage caused by misuse of the article.
Any claim made or repair made during the warranty period will be subject to mandatory presentation of the invoice.
- 10 -
