Connect the backrest harness.
Push the backrest forward and let it lean on the seat pad.
Use the bolt and cotter pin to attach the backrest and backrest actuator.
Take note of the notch position on the connector.
Locate the connecter on the main PCB box.
Attach backrest bracket to reclining actuator.
Push the backrest forward and let it lean on
the seat pad.
Aline the two brackets.
Lock the bolt by cotter pin.
Connect the backrest 4-way air hose connecter. Then line up the air hose against the side board.
Completed connection.
Securely attach the connector to the base.
Make sure it locks into place.
Connect the air hose connecter.
Push air-hose toward the front of the chair
so that it is out of the way.
8
9
10
Summary of Contents for OG812
Page 1: ...INSTALLATION MANUAL OG812 ...
