74
4 6 Differential Control
4 6 Differential Control
In certain applications it is necessary to control a second process such that its
process value always deviates from the first process with a constant value. To
achieve this, set the following parameter in the Setup menu.
In certain applications it is necessary to control a second process such that its
process value always deviates from the first process with a constant value. To
achieve this, set the following parameter in the Setup menu.
FUNC=FULL
IN1,IN1L,IN1H are set according to input 1 signal
IN2,IN2L,IN2H are set according to input 2 signal
IN1U, DP1, IN2U, DP2, are set according to input 1 and input 2 signal
PVMD=P1-2 or P2-1
SPMD=SP1.2
FUNC=FULL
IN1,IN1L,IN1H are set according to input 1 signal
IN2,IN2L,IN2H are set according to input 2 signal
IN1U, DP1, IN2U, DP2, are set according to input 1 and input 2 signal
PVMD=P1-2 or P2-1
SPMD=SP1.2
The response of PV2 will be parallel to PV1 as shown in the following diagram
The response of PV2 will be parallel to PV1 as shown in the following diagram
Time
PV
=Set point
=Set point
PV1
PV2
PV=PV1
PV2
or
PV2
PV1
Set point=SP1 or SP2
PV=PV1
PV2
or
PV2
PV1
Set point=SP1 or SP2
The PV will be displayed as a difference between PV1-PV2 if P1-2 is chosen
for PVMD, or PV2-PV1 if P2-1 is chosen for PVMD. If you need PV1 or PV2 to
be displayed instead of the differential PV, you can use the Display Mode to
select PV1 or PV2 to be viewed. See Section 3-23.
The PV will be displayed as a difference between PV1-PV2 if P1-2 is chosen
for PVMD, or PV2-PV1 if P2-1 is chosen for PVMD. If you need PV1 or PV2 to
be displayed instead of the differential PV, you can use the Display Mode to
select PV1 or PV2 to be viewed. See Section 3-23.
Setup
PVMD=P1-2
or PVMD=P2-1
PVMD=P1-2
or PVMD=P2-1
Error Message
Error Message
Figure 4.4
Relation between PV1 and PV2
for a Differential Control
Figure 4.4
Relation between PV1 and PV2
for a Differential Control
If PVMD selects P1-2 or P2-1, while SPMD selects PV1 or PV2, an
Error Code will appear.
If PVMD selects P1-2 or P2-1, while SPMD selects PV1 or PV2, an
Error Code will appear.
SPMD=SP1.2
In this case the signals used for input 1 and input 2 should be the same unit
and same decimal point, that is, IN1U=IN2U, DP1=DP2, otherwise
Error Code will appear.
In this case the signals used for input 1 and input 2 should be the same unit
and same decimal point, that is, IN1U=IN2U, DP1=DP2, otherwise
Error Code will appear.
Error Messages
Error Messages
