48
Table A.1 Error Codes and Corrective Actions
Error
Code
Display
Symbol
Error Description
Corrective Action
Illegal setup values been used:
Before COOL is used for OUT2,
DIRT ( cooling action ) has already
been used for OUT1, or PID mode
is not used for OUT1 ( that is PB
= 0, and / or TI = 0 )
4
Communication error: bad
function code
10
Correct the communication software to meet the
protocol requirements.
Communication error: register
address out of range
11
Don't issue an over-range register address to the slave.
Communication error: attempt to write
a read-only data or a protected data
14
Don't write a read-only data or a protected data
to the slave.
Communication error: write a
value which is out of range to a
register
15
Don't write an over-range data to the slave register.
26
Fail to perform auto-tuning
function
EEPROM can't be written correctly
29
Return to factory for repair.
Input sensor break, or input
current below 1 mA if 4-20 mA is
selected, or input voltage below
0.25V if 1 - 5V is selected
39
Replace input sensor.
40
A to D converter or related
component(s) malfunction
Return to factory for repair.
1.The PID values obtained after auto-tuning procedure
are out of range. Retry auto-tuning.
2.Don't change set point value during auto-tuning
procedure.
3.Use manual tuning instead of auto-tuning.
5. Don’t set a zero value for TI.
4. Don't set a zero value for PB.
6. Touch RESET key
Cold junction compensation for
thermocouple malfunction
30
Return to factory for repair.
Check and correct setup values of OUT2, PB, TI and
OUT1. IF OUT2 is required for cooling control, the
control should use PID mode ( PB = 0, TI = 0 ) and
OUT1 should use reverse mode (heating action),
otherwise, don't use OUT2 for cooling control.
No product returns may be accepted without a completed Return Material Authorization (RMA) form.
RETURNS
Chromalox warrants only that the Products and parts manufactured by Chromalox, when shipped, and the work performed by Chromalox when performed, will meet all applicable specification and
other specific product and work requirements (including those of performance), if any, and will be free from defects in material and workmanship under normal conditions of use. All claims for
defective or nonconforming (both hereinafter called defective) Products, parts or work under this warranty must be made in writing immediately upon discovery, and in any event, within one (1) year
from delivery, provided, however all claims for defective Products and parts must be made in writing no later than eighteen (18) months after shipment by Chromalox. Defective and nonconforming
items must be held for Chromalox’s inspections and returned to the original f.o.b. point upon request. THE FOREGOING IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES WHATSOEVER,
EXPRESS, IMPLIED AND STATUTORY, INCLUDING, WITHOUT LIMITATION, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
Notwithstanding the provisions of this WARRANTY AND LIMITATION Clause, it is specifically understood that Products and parts not manufactured and work not performed by Chromalox are
warranted only to the extent and in the manner that the same are warranted to Chromalox by Chromalox’s vendors, and then only to the extent that Chromalox is reasonably able to enforce such
warranty, it being understood Chromalox shall have no obligation to initiate litigation unless Buyer undertakes to pay all cost and expenses therefor, including but not limited to attorney’s fees, and
indemnifies Chromalox against any liability to Chromalox’s vendors arising out of such litigation.
Upon Buyer’s submission of a claim as provided above and its substantiation, Chromalox shall at its option either (i) repair or replace its Products, parts or work at the original f.o.b. point of
delivery or (ii) refund an equitable portion of the purchase price.
THE FOREGOING IS CHROMALOX’S ONLY OBLIGATION AND BUYER’S EXCLUSIVE REMEDY FOR BREACH OF WARRANTY, AND IS BUYER’S EXCLUSIVE REMEDY AGAINST CHROMALOX
FOR ALL CLAIMS ARISING HEREUNDER OR RELATING HERETO WHETHER SUCH CLAIMS ARE BASED ON BREACH OF CONTRACT, TORT (INCLUDING NEGLIGENCE AND STRICT
LIABILITY) OR OTHER THEORIES, BUYER’S FAILURE TO SUBMIT A CLAIM AS PROVIDED ABOVE SHALL SPECIFICALLY WAIVE ALL CLAIMS FOR DAMAGES OR OTHER RELIEF, INCLUDING
BUT NOT LIMITED TO CLAIMS BASED ON LATENT DEFECTS. IN NO EVENT SHALL BUYER BE ENTITLED TO INCIDENTAL OR CONSEQUENTIAL DAMAGES AND BUYER SHALL HOLD
CHROMALOX HARMLESS THEREFROM. ANY ACTION BY BUYER ARISING HEREUNDER OR RELATING HERETO, WHETHER BASED ON BREACH OF CONTRACT, TORT (INCLUDING
NEGLIGENCE AND STRICT LIABILITY) OR OTHER THEORIES, MUST BE COMMENCED WITHIN ONE (1) YEAR AFTER THE DATE OF SHIPMENT OR IT SHALL BE BARRED.
A.2 WARRANTY AND LIMITATION OF REMEDY AND LIABILITY
