Step 4: Clean Main Unit
Disconnect extension cord(s) from electrical outlet(s) & wipe with rag as
they are being wound up
Store on hanger in designated area
Wheel unit to loca
�
on that has a drain & clean water hose
Pull discharge hose from clamp on front of machine, remove plug and
gently lay down to the drain
Remove clear round lid from the Dirty Solu
�
on tank
Hose down interior of Dirty Solu
�
on tank un
�
l water runs clear
NOTE: PAY CAREFUL ATTENTION TO RINSE THE EXTERIOR OF
THE WIRE FLOAT CAGE LOCATED IN THE UPPER LEFT CORNER OF
THE TANK
Once the Dirty Solu
�
on Tank is empty push discharge hose back into clamp
Wipe down exterior of unit & threads of Dirty Solu
�
on tank lid
Store unit in designated area*
*When storing unit, it is recommended to leave discharge hose unplugged & lid to the Dirty
Solu
�
on tank o
ff
to allow interior of unit to dry out.
Weekly Maintenance:
Step 1: Lubricate Quick Disconnect
NOTE: ONLY USE A SILICONE SPRAY COMPATIBLE w/RUBBER
Spray the
en�r
e inside of the female quick disconnect
fi�
ng being sure
to coat the ball bearings & spin the collar
Spray the exterior of the male quick disconnect
fi�
ng while pressing in
the middle pin
Repeatedly connect & disconnect the
fi�
ngs together un
�l
male
fi�
ng
‘pops out’ easily when disconnected (usually 3-4
�
mes is su
ffic
ient)
Step 2: Lubricate Trigger Valve
Spray Trigger Valve located in the ‘V’ between yellow p
las�c
trigger &
the bo
�
om of the handle
Gently work trigger to disperse lubricant
Step 3: Clean & lubricate any connec
�
ons where easy removal is desired
(For example)
Threads to Dirty Solu
�
on tank lid
Solu
�
on line connectors
Floor tool metal pipe to vacuum handle
Floor tool metal pipe sec
�
ons
Vacuum head to pipe
Summary of Contents for ANIVAC ProHeat II
Page 3: ......