43 52
13
1
25
23
Attach the corner brackets to the
side and roof beams. Lay the
bracket above the two beams and
secure loosely.
Bolt the floor bar to the inside of
the corner beams, securing at
each corner
STEP
2
Secure the support poles to the
outer side of the floor bar. Attach
the diagonal supports to the
inside of the floor bar and support
poles, all with the same bolt.
Slide an extra bolt into the groove
of the support pole. Then bolt the
top of the support poles to the
outside of the top roof beams
using another bolt.
On the inside of each corner bracket,
attach the diagonal supports to the
lowest bolt and the horizontal support
to the second-to-lowest bolt. Open the
bolts, position the supports, and
refasten the bolts.
STEP
5
Bolt the two short horizontal
supports to the insides of the
support poles.
STEP
6
Attach the top doorway beam to the
outside of the roof beams, using the
top hole in the beam. Next insert a
bolt from the outside into the lower
hole at each end, securing loosely
with a nut.
STEP
7
Follow the steps below to assemble the Front Wall.
NOTE:
Each step applies to both relevant corners/supports.
Note:
Steps 1 - 5
follow the same
steps used for the
back wall.
43 52
17
01
03
07
12
43 52
23
06
PAGE 13
STEP
4
43 52
03
07
STEP
1
13
43
01
02
52
STEP
3
25
07
17
07
03
