Slide the door rail onto the bolt heads,
starting on the left until it reaches the
right end of the top doorway beam.
(Note: when you stand the wall up, the
rail will extend on the left of the
greenhouse.) When the rail is in place,
tighten the two bolts.
STEP
1
Insert a bolt into the hole at the end
of the door rail, securing with a nut.
This will act as a door stop.
STEP
4
Attach the vertical door rail
support to the end of the door rail
that is jutting out of the structure.
STEP
3
Secure the bottom of the vertical door
rail support to the outside of the roof
beam, using the long door support
bolt. Slide the door spacer onto the
bolt between the two poles, securing
the joint with a nut on the inside of
the roof beam.
Follow the steps below to assemble the Door Frame.
PAGE 14
14
02
12
06
43 52
14
19
19
03
38 39 52
STEP
2
12
14
02
06
Turn the assembled wall over so that the outside is now facing you, to make
attaching the door frame easier.
