7000 SERIES INDICATORS
EN 61
Start Threshold
The Start Threshold appears in the menu tree only when Auto Start is Enabled. It defines the scale weight value
above which the averaging process will begin after stability is reached.
Valid settings are from 0 to the full scale capacity. This value should be relatively high
– for example, 80% of the
estimated weight of all animals on the scale. A very low number may cause the sampling period to start before all
the animals are on the scale.
Auto Print
This Auto Print setting overrides the basic weighing Auto Print function, configured in setup at Scale > Log or Print
> Automatic when operating within the application.
When Auto Print is enabled, the processed weight value is displayed for the amount of time defined by the Print
Delay setting, and then a transaction print is automatically triggered.
This feature can be Enabled or Disabled. By default, it is Disabled.
Print Delay
Print Delay is only shown in the menu tree when Auto Print is enabled. It determines the delay between completion
of the transaction and triggering the transaction print.
Valid settings are from 0 to 10 seconds in 1 second increments. The default value is 5.
Display
Line 2
The Line 2 assignment determines what data is displayed during and after a transaction. It is selected from a drop-
down list. The selection list varies depending on the Mode selected:
Selection
Function
Mode 1
Mode 2
Disabled
Line 2 is blank.
Average
Not available
Line 2 shows Average
weight per animal
ID
Line 2 shows the
transaction ID
Line 2 shows the
transaction ID
The default value is Disabled.
4.2.4
Operating Sequence
The following sections describe the two modes of operation of the animal weighing application:
Mode 1
Determines the average total weight of a single animal or multiple
animals
Mode 2
Determines the average total weight of multiple animals, and
calculates the average weight per animal
Mode 1 Operation
Begin with the scale empty and the terminal in the Animal Weighing application.
The display will prompt either Press
ENTER
to start. In normal operation or if Auto Start is enabled, the system will
prompt Add weight > xxx (i.e., greater than xxx), where xxx is the programmed threshold weight.
Press ZERO
to capture an accurate zero reference.
If required, a transactional ID may be entered via the ID key
. If programmed in setup, the ID will be shown on
Line 2 at the bottom of the display.
Add the desired number of animals to the scale and then press the
ENTER
key
to start the weighing cycle. If
Auto Start is enabled, the cycle will start automatically when the weight on the scale exceeds the programmed
threshold and there is no-motion on the scale.
Summary of Contents for 7000 Series
