Adventurer Pro
EN-9
3.3 Basic Operation
3.3.1 Zeroing
Remove the load from the pan and press the
Zero
button to set the display to zero. The
Center of Zero indicator turns on when the
measurement is 1/4 d of the zero
setting.
3.3.2 Taring
•
Tare
button - Place the container on the
pan and press the
Tare
button. Net weight
is displayed. To clear the Tare value,
remove the container from the pan and
press the
Tare
button.
•
Auto Tare - Set Auto Tare to ON in the
Setup sub-menu. The secondary display
shows PLACE CONTAINER (blinking).
When the container is placed on the pan,
it is automatically tared and Net weight is
displayed. The Tare value is cleared
automatically when the container is
removed from the pan.
•
Preset Tare - A preset tare value may be
entered using the xT command in the
command table. To clear the Tare value,
enter a value of 0.0.
3.3.3 Changing Units of Measure
Press and hold the
Unit
button, release it when
the desired unit is displayed.
Note
: If the desired unit is not displayed, it must
be turned on in the Unit menu.
3.3.4 Changing Application Modes
Press and hold the
Mode
button, release it when
the desired mode is shown on the secondary
display.
Note
: If the desired mode is not displayed, it
must be turned on in the Mode menu.
3.3.5 Printing Data
Press the
button to send the displayed
value to the COM port. The port must have
Auto Print set to OFF.
Summary of Contents for Adventurer Pro AV53
Page 2: ......
