Defender 2200 Bench Scale
EN-25
3.9.7
Lock Print
Set the status.
OFF
= Print menu is not locked.
ON
= Print menu is locked and hidden
3.9.8
End Lock
Advance to the next menu.
3.9
End Menu
Exit to weighing.
3.10
Security Switch
A security switch is located on the Main PCB board. When the switch is set to the on position, user menu settings
that were locked in the Menu Lock can not be changed. Open the housing as explained in Section 2.3.1. Set the
position of security switch to ON as shown in Figure 1-2.
4 OPERATION
4.1
Turning Indicator On/Off
To turn the Indicator on, press the and hold the
ON/ZERO Off
button for 2 seconds.
The Indicator performs a display test, momentarily displays the software version, and
then enters the active weighing mode.
To turn the Indicator off, press and hold the
ON/ZERO Off
button until OFF is
displayed.
4.2 Zero
Operation
Zero can be set under the following conditions:
•
Automatically at Power On (initial zero).
•
Semi-automatically (manually) by pressing the
ON/ZERO Off
button.
•
Semi-automatically by sending the Zero command (Z or alternate zero
command).
Press the
ON/ZERO Off
button to zero the weight display. The scale must be stable to
accept zero operation.
4.3 Manual
Tare
When weighing an item that must be held in a container, taring stores the container
weight in memory. Place the empty container on the scale (example 0.5 kg) and press
the
TARE
button. The display will show the net weight.
To clear the Tare value, empty the scale and press the
TARE
button. The display will
show the gross weight.
