EN-30 Defender 5000 Indicators
3.9.1.3 Stop Bits
Set the stop bits.
1 BIT
2 BIT
3.9.1.4 Handshake
Set the flow control method.
NONE
= no handshaking
XON/XOFF
= XON/XOFF handshaking
HARDWARE
= hardware handshaking (COM1 menu only)
3.9.1.5 Alternate Print Command
Set the alternate command character for Print.
Settings of A(a) to Z(z) are available. The default setting is
P
.
3.9.1.6 Alternate Tare Command
Set the alternate command character for Tare.
Settings of A(a) to Z(z) are available. The default setting is
T
.
3.9.1.7 Alternate Zero Command
Set the alternate command character for Zero.
Settings of A(a) to Z(z) are available. The default setting is
Z
.
3.9.1.8 Reset
Reset the settings to factory default.
3.9.2 Print Setup of RS232/2nd RS232
3.9.2.1 Demand
If
Demand
is selected, the sub-menu
Stable Only
will display.
Set the printing criteria.
OFF
= values are printed immediately, regardless of stability.
ON = values are printed only when the stability criteria are met.
Note:
For more detailed information, please refer to Section 5.3 Printout.
3.9.2.2 Auto On Stable
If
Auto On Stable
is selected, the sub-menu
Mode
will display.
Set the printing mode.
Load = Prints when the displayed load is stable.
Load and Zero = Prints when the displayed load and zero reading is stable.
3.9.2.3 Auto On Accept
If
Auto On Accept
is selected and the weighing mode is
Check
, values will be printed when the weight
is accepted.
ACCEPT = printing occurs each time the display is within the Checkweigh accept
range and stability criteria are met.
3.9.2.4 Interval
If
Interval
is selected, the sub-menu
Time
will display.
INTERVAL = printing occurs at the defined time interval.
The time interval can be set through the numeric keypad.
Settings of 1 to 3600 seconds are available. Default is 0.
Printing occurs at the defined time interval.
