EN-44 Defender 5000 Indicators
Select the list item and press the Softkey
corresponding to the icon
to change the
settings as desired.
To return to the Application home screen, press
the Softkey corresponding to the icon
.
The Percent Configurations are defined below
(defaults in
Bold
).
Configure Item
Option(
Bold
is default)
Description
Auto Tare
Off
/On
Off
: Auto tare is turned off.
On: The first stable weight (>=5d) will be tared as a
container automatically.
Accumulate
Off
/Manual/Automatic
Off
: The Softkey
"∑" doesn't display.
Manual: The Softkey
"∑" displays. User can press
the key to accumulate the stable weight.
Automatic: The Softkey
"∑" displays. The weight
will be accumulated automatically.
Note:
The load to be accumulated has to be >= 5d and
the next accumulation can only start once the pan
has been cleared.
When LFT is ON (no such limit when LFT is OFF
or the approved model is OIML),
a. gross weight and net weight cannot be
accumulated;
b. gross 0 has to be reached before a new sample
accumulation.
When LFT is OFF,
a. gross weight and net weight can be accumulated
at the same time;
b. a new sample can be accumulated after
reaching gross 0 or net 0.
4.4.3 Input/Output (I/O) Setup
The I/O’s setup can be customized for various user preferences.
The I/O’s setup is defined below
(defaults in
Bold).
Item
Available Settings
Enable
On,
Off
Note:
The I/O’s will only work when the I/O Option board has been installed. See the accessory list in
section 9.4 for information. The option I/O board provides two isolated inputs and four dry-contact
normally open relay outputs which can be used for simple process weighing.
Press the button
to enter the Main Menu.
With the Softkey corresponding to the icon
, go
down the list and highlight
Application Mode
.
Enter this sub-menu by pressing the button
corresponding to the icon
.
