EN-8
EXPLORER BALANCES
2.2
Installing Components
Refer to the illustrations and instructions below to identify and assemble your Explorer balance with its components.
All components must be assembled before using the balance.
2.2.1
Terminal Setup
When the Explorer is delivered, the Terminal is already attached (docked) to the Base. No additional setup is
necessary. However, for Draft Shield models, the Terminal needs to be detached temporarily in order to assemble
parts of the Draft Shield. Refer to the illustrations and instructions below to identify and assemble your Explorer
Balance.
Note:
The Terminal is identical for all Explorer Balance models.
2.2.2
Installing the Wind Ring, Weighing Platform on Semi-Micro models
Note:
Assembly instructions also apply to models with the suffix M or N.
1. Place the Wind Ring in position.
2. Insert the Platform Assembly
onto the Mounting Cone located
in the center of the Balance.
2.2.3
Installing the Wind Ring, Weighing Platform on Models EX124
1
, EX224
1
, and EX324
1
Note:
Assembly instructions also apply to models with the suffix M or N.
3. Place the Wind Ring in position.
4. Insert the Platform Assembly
onto the Mounting Cone located
in the center of the Balance.
2.2.4
Installing the Sub-Platform and Weighing Pan on Models EX223
2
, EX423
2
, EX623 and EX1103
1. Place the Sub-platform in
position.
2. Position the Platform on the
Sub-platform.
