EXPLORER BALANCES
EN-125
5.13 Factory Reset
Use this sub-menu to reset the menus to their Factory default settings.
5.13.1 Factory Reset Sub-menu
Calibration
Reset
User Settings
Reset
Balance Setup
Reset
Application
Modes Reset
Weighing Units
Reset
GLP and GMP
Data Reset
Communication
Reset
Reset All
5.13.2 Reset Calibration
Select
YES
to return all Calibration menu items to their factory settings.
5.13.3 Reset User Settings
Select
YES
to return all User Settings menu items to their factory settings.
5.13.4 Reset Balance Setup
Select YES to return all Balance Setup menu items to their factory settings.
5.13.5 Reset Application Modes
Select
YES
to return all Application Modes menu items to their factory settings.
5.13.6 Reset Weighing Units
Select
YES
to return all Weighing Units menu items to their factory settings.
5.13.7 Reset GLP and GMP Data
Select
YES
to return all GLP and GMP Data menu items to their factory settings.
5.13.8 Reset Communication
Select
YES
to return all Communication menu items to their factory settings.
5.13.9 Reset All (Global Reset)
Select
YES
to return all the menu items to their factory settings. The two touchless sensor's LEDs will
blink during resetting and go out when the reset is finished.
This selection will clear all the user and library records.
5.14 Securing the Menu and Key Lock menu settings
A slide switch is used to secure the Lock menu settings. When the switch is set to the ON position, the Lock menu
settings may be viewed but not changed. This switch is located under the Base.
Set the position of the switch to ON by sliding the external Lock Switch to LOCKED as shown in Section 6.
When the switch is in the ON position, the startup display includes the LOCK ON message.
Note:
This switch is also used in conjunction with the Legal for Trade menu item. When the Legal for Trade menu
is set to ON, the switch must be set to the ON position to prevent calibration and changes to metrologically
significant settings. Refer to Section 6 for more information.
