28
Error Codes (Cont.)
Error Codes (Cont.)
Error Codes (Cont.)
Error Codes (Cont.)
Error Codes (Cont.)
CheckSum Errors
CheckSum Errors
CheckSum Errors
CheckSum Errors
CheckSum Errors
9.0
Bad factory checksum. If error persists, have the balance serviced.
9.5
Bad factory calibration checksum. If error persists, have the balance serviced.
9.6
Bad mode checksum. Turn the balance off using the front panel controls. If
the error persists, have the balance serviced.
9.7
Invalid setup data checksum. Check Setup, User and Print menu (when
RS232 is installed) settings. If possible, try to enter menus and exit using END
to restore menu settings. May be caused by a faulty component, or in rare
cases, a severe static charge. If error persists, balance must be serviced.
9.8
Hardware error causing invalid calibration data checksum. Balance may need
recalibration - particularly linearity calibration. If error persists, balance must be
serviced.
9.9
Invalid temperature compensation checksum. Balance will work with default
temperature compensation data, however, error will occur each time balance
is turned on. Have balance serviced.
SERVICE INFORMATION
SERVICE INFORMATION
SERVICE INFORMATION
SERVICE INFORMATION
SERVICE INFORMATION
If the Troubleshooting section does not resolve or describe your problem, you will
need to contact an authorized Ohaus Service Agent. For Service assistance in the
United States, please call Ohaus Corporation toll-free at (800) 526-0659, an Ohaus
Product Service Specialist will be available to help you.
