RANGER
®
7000 SCALES
EN-17
The
Configuration
screen is now displayed.
Select the list item and press the button
corresponding to the
icon to change the
setting as desired.
To return to the Application home screen, press
the button corresponding to
.
The Counting Configurations are defined below
(defaults in
Bold
).
Item
Available Settings
Comments
Auto Tare
On,
Off
Turns Automatic Tare on/off
Chain Tare
On
, Off
To enable Chain (Continuous)Tare
Accumulate
Off , Automatic,
Manual
To enable Accumulation / Totalization
Auto Opt.*
On
, Off
To enable Automatic Optimization of APW
APW Auto Save*
On
, Off
To enable APW Automatic save
Opt. Beep
On
, Off
To enable Optimization Beep
Note:
* If APW value is directly entered (not through sampling), this feature does not work.
4.2.3
Accumulation
See section 4.1.2 for details about the Accumulation feature.
4.2.4
Input/Output (I/O) Setup
The I/O’s can be customized for various user preferences.
The I/O’s are defined below
(defaults in
Bold).
Item
Available Settings
Discrete Input 1
Off,
Zero, Tare, Clear Tare, Print, Unit, Accumulate
Discrete Input 2
Off,
Zero, Tare, Clear Tare, Print, Unit, Accumulate
Discrete Output 1
Off,
Overload, Underload
Discrete Output 2
Off,
Overload, Underload
Discrete Output 3
Off,
Overload, Underload
Discrete Output 4
Off,
Overload, Underload
Note:
The I/O’s will only work when the I/O Option Board have been installed. See the Accessory list in section 9.4
for information.
The option I/O board provides two isolated inputs and four dry-contact normally open relay outputs which can be
used for simple process weighing.
Press the
button to enter the Main Menu.
With the button corresponding to the
icon, go down
the list and highlight
Application Mode
. Enter this sub-menu
by pressing the button corresponding to the
icon.
