EN-60
RANGER
®
7000 SCALES
7.
LEGAL FOR TRADE
When the scale is used in trade or a legally controlled application it must be set up, verified and sealed in
accordance with local weights and measures regulations. It is the responsibility of the purchaser to ensure that all
pertinent legal requirements are met.
7.1
Settings
Before verification and sealing, perform the following steps in order:
1. Verify that the menu settings meet the local weights and measures regulations.
2. Units menu should be reviewed. Verify the units turned on meet the local weights and measures
regulations.
3. Perform a calibration as explained in Section 5.
3. Set the position of the Security Switch to the locked position.
7.2
Verification
A weights and measures official or authorized service agent must perform the verification procedure.
7.3
Sealing
After the scale has been verified, it must be sealed to prevent undetected access to the legally controlled settings.
Before sealing the device, ensure that the security switch is in the Locked position and the Legal for Trade setting
in the scale Setup menu has been set to ON.
If using a wire seal, pass the sealing wire through the holes in the security screw and tab, as shown.
If using a paper seal, place the seal over the flat head screw as shown
A. Base
Un-Locked
Locked with Wire Seal Locked with Paper Seal
B. Terminal
Un-locked
Locked with Wire Seal Locked with Paper Seal
Note:
The Terminal only needs to be sealed if a second scale is attached to the optional 2
nd
A/D board.
