Ranger 7000
®
Series Service Manual
15
Ohaus Corporation www.ohaus.com
3.2
OPENING THE SCALE
Opening the Ranger 7000
®
scale varies slightly according to the specific model, as detailed below.
Use these procedures in order to replace the Load Cell, the Printed Circuit Board or other
components.
Common hand tools are sufficient to disassemble the Ranger 7000
®
scale s.
3.2.1
Preparation for Opening Ranger 7000
®
Models
1. Turn the scale off and unplug the power cord before you begin.
2. Disconnect any communication or other option cables.
3.3
OPENING THE TERMINAL MODULE
*Below show a Ranger7000 MFR small housing model R71MHD6.
3.3.1 Detaching the Terminal from the base.
1. Switch off and disconnect the scale from main power supply.
2. Detach the display terminal from the base by pressing both release buttons at the same time
as show below picture. After that pull the Terminal towards you (outward) until the Terminal is
detached from the base as show below.
Summary of Contents for Ranger 7000 R71MHD3
