EN-2 RS232 Interface
2
. Install the Interface PCB. Push it through the pins and secure it with the 3 screws.
3
. Connect an RS232 Cable (not supplied in this kit).
4
. Place the cord in the groove (see step 2) and put the red interface option cover back on.
SETUP
A)
The OHAUS Interface is preset to communicate using the following settings: 9600 baud, 8 bit,
no parity, no handshake. Determine the RS232 parameters required for the printer or computer
that is to be connected. See computer or printer documentation if assistance is required. If the
parameters do not match, it will be necessary to change either the scale’s settings, or the
computer / printer settings.
B)
Upon installation of the interface, the scale will recognize the RS232 Interface and add relevant
items to the menu. Configure the scale to the desired RS232 and printing parameters; refer to
the scale’s Instruction Manual for assistance in using the menus.
Pins
Screws
Cord groove
Summary of Contents for ranger 7000
