Ranger™ Count 3000 Series EN-15
4.3 Setup Menu
Enter this menu to set scale parameters. Default settings are in
bold
.
Reset
[
reset
]
Reset the Setup menu to factory defaults.
NO
= not reset
YES
= reset
Dual Scale [
d.scale
]
Set the status of the second scale input (Scale 2).
OFF
= disabled
ON
= enabled
Cap2 [
CAP2
]
Set the capacity of Scale 2.
1…9999
Grad2 [
GrAd2
]
Set the readability of Scale 2.
0.00005…0.5
Power on unit
[
pwWr.UN
]
Set the unit of measure displayed at startup.
AUTO
= last unit in use when turned off
kg
= kilograms
g
= grams
lb
= pounds
oz
= ounces
lb:oz
= pound ounces
Zero Range
[
ZErO
]
Set the percentage of scale capacity that may be zeroed.
2%
= zero up to 2 percent of capacity
10%
= zero up to 10 percent of capacity
Auto Opt [
A.OPt
]
Set the Automatic Optimization.
OFF
= disabled
ON
= APW automatically optimized
Reset:
no
, yes
Dual Scale:
off
, on
Cap2:
1
…9999
Grad2:
0.00005…0.5
Power on unit:
auto
, kg, g, lb, oz, lb:oz
Zero Range:
2%,
10%
Auto Opt:
off,
on
Auto Tare:
on,
off
, on-acc
Beeper Opt:
off,
on
Beeper Signal:
off
, accept, under, over, under-over
Beeper Key:
off
, on
Accumulation:
off, auto,
manual
End Setup:
Exit menu
