Ranger
™
4000 Count Series EN 21
Reset the Lock menu to factory defaults.
NO
= no reset
YES
= reset
Lock Cal
[
l.CAL
]
Set the status.
OFF
= Calibration menu is not locked
ON
= Calibration menu is locked
Lock Setup
Set the status.
OFF
= Setup menu is not locked
ON
= Setup menu is locked
Lock Read
Set the status.
OFF
= Readout menu is not locked
ON
= Readout menu is locked
Lock Unit
[
l.Unit
]
Set the status.
OFF
= Unit menu is not locked
ON
= Unit menu is locked
Lock Print
Set the status.
OFF
= Print menu is not locked
ON
= Print menu is locked
Lock COM
[
l.COmM
]
Set the status.
OFF
= COM menu is not locked
ON
= COM menu is locked
End Lock
[
End
]
– Advance to the next menu or return to the top of the current menu.
4.9 End Menu
Press ‘Yes’ to advance to the Calibration menu. Press ‘No’ to exit the menu and return to the
current application mode.
4.10 Additional Features
To use this feature, remove AC power from the scale and remove the protective cover for the
weigh below opening. Install a suitable hook into the access hole at the bottom of the scale as
shown. Do not over tighten, tighten finger tight. Mount the scale onto an appropriate assembly
that allows free working space below the hook. See figure 4-1. Refer to section 6.4 for optional
hook.
Note:
Never allow the scale to rest directly on the hook.
