EN-10 SCOUT
TM
SERIES BALANCES - SPX
4.3 Setup Menu
Enter this menu to set balance parameters.
Note:
Bold
always represents factory default value
Reset
[
reset
]
Reset the Setup menu to factory defaults.
NO
= not reset
YES
= reset
Filter
[
FILtEr
]
Set the amount of signal filtering.
LOW
= less stability, faster stabilization time
MED
= normal stability, stabilization time
HI
= greater stability, slower stabilization time
AZT
[
AZt
]
Set the automatic zero tracking functionality.
OFF
= disabled
0.5d
= the display will maintain zero until a change of 0.5 divisions per second has
been exceeded.
1d
= the display will maintain zero until a change of 1 divisions per second has been
exceeded.
3d
= the display will maintain zero until a change of 3 divisions per second has been
exceeded.
Stable Range
[
Stable
]
Set the amount the reading can vary while the stability symbol remains on.
0.5d
= 0.5 balance division
1d
= 1 balance division
2d
= 2 balance division
5d
= 5 balance division
Back Light
[
LIGHt
]
Sets backlight functionality.
OFF
= always off
ON
= always on
AUTO = turns on when a button is pressed or the displayed weight changes.
Note: When connected with power pack, the backlight is always on.
Auto Tare
[
A.tArE
]
Set the automatic tare functionality.
OFF
= Automatic Tare is disabled
ON
= the first stable gross weight is tared
ON-ACC = stable gross loads within the accept limits are tared (in Check weighing mode)
Reset:
no
, yes
Filter:
Low,
Med
, High
Auto Zero Tracking:
off,
0.5d
, 1d, 3d
Stable:
0.5d,
1d
, 2d, 5d
Backlight:
off, on,
auto
Auto Tare:
off
, on, on-acc
Auto Off:
off
, 1, 5, 10
End Setup:
Exit menu
