EN-6 SD SERIES BENCH SCALE
•
Low Battery Indication
:
The battery symbol on the left side of the
display indicates a low battery condition. When first displayed ,
approximately 12 hours of operation remain. When the battery is fully
depleted, the scale will momentarily display “Lo bAt” and shut off.
Operation
•
Power Up Test
:
When the
ON/ZERO
Off
button is pressed, the scale
is turned on, all display segments will appear for a short time, followed by
the software version. The display will then reset to zero.
•
Zero Function
:
By pressing the
ON/ZERO
Off
button, the scale display
returns to zero. When adding additional mass, the
ON/ZERO
Off
button
may be used repeatedly until the full capacity of the scale is reached.
When a container is used, the
ON/ZERO
Off
button may be used to
simulate a Tare function. Additional mass may then be added as a NET
weight. When removing both the sample and container from the scale, a
negative value may be displayed. Zero the scale again before subsequent
usage.
NOTE:
The
ON/ZERO
Off
button will perform a true zero setting function when
displayed values are 2% of full capacity. Above 2%, the range is
limited to full capacity by subtraction.
•
Negative Values
:
When a load is removed from the scale, any previously
zeroed value will be displayed as a negative number. To return to normal
operation, the negative value is cleared from the display by pressing the
ON/ZERO
Off
button.
•
Overload
:
If the applied load exceeds the capacity of the scale, an “E” is
displayed. Remove the load and the scale will return to normal operation.
SD-Manual original.indb 6
9/8/2006 3:09:51 PM
