14
2.7 Switching the balance on and off
Your balance is on at all times when connected to a power source, the display is on initially and can be turned off.
To
switch the balance on
, press the
button. As soon as the weight
display appears, your balance is ready.
To
switch the balance off
, press the
button. After the balance has been
switched off, your balance is in the standby mode. If you wish to perform a
weighing, press the
button again.
As your balance needs no warm-up time when in the standby mode and is
immediately ready for weighing, we advise you to switch the display off by
use of the
button and not to disconnect it from the power supply. This
also ensures that the balance is always in thermal equilibrium.
0.000
BASIC WEIGHING
2.8 Weigh below preparation
The Voyager balance is equipped with a weigh below hook at the bottom of the balance. To use this fea-
ture, remove power from the balance and remove the protective cover underneath the balance. See illustra-
tion for location. The balance can be supported using lab jacks or any other convenient method. Make
sure the balance is level and secure. Apply power and operate the balance. Attach items to be weighed to
the hook underneath the balance.
Installation
Summary of Contents for Voyager V10640
